Comments to this Manuals Your Name. Ensure that the edge connector is correctly seated in the slot. Checking Jumper Settings Do not over-tighten the screws as this can stress the motherboard. Refer to the illustration below for proper installation: Installing Hardware Installing the Processor Caution: Secure the metal bracket of the card to the system case with a screw. Attach the other cable end to the SATA hard drive.
|Date Added:||13 December 2017|
|File Size:||6.13 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
In a software power down, the system can be resumed by Wake Up Alarms.
Continue this process to complete the drivers installation. Refer to the table below for information: Increase the separation between the equipment and the receiver.
Handle this page with caution. Reorient or relocate the receiving antenna. Page 53 Click Next.
Integrated Peripherals This page sets up some parameters for peripheral devices connected to the system. Refer to the following: Ensure that the edge connector is correctly seated in the slot.
If the feature is enabled, it will enhance hard disk performance by reading or writing more data during each transfer. Expansion Slots Expansion Slots Installing Add-on Cards The slots on this motherboard are designed to hold expansion cards and connect them to the system bus.
Integrated Peripherals Integrated Peripherals This page sets up some parameters for peripheral devices connected to g3t1-m3 system. The following screen appears: Attach the other cable end to the SATA hard drive.
The main menu of the Setup Utility displays a list of the options that are available. Trouble Shooting Chapter 5 Trouble Shooting Start up problems g3t1-m3 assembly After assembling the PC for the first time you may experience some start up problems.
Comments to this Manuals Your Name. Click Next run the Installation Wizard. Jumpers with more than one pin are numbered.
Page 10 Memo Introducing the Motherboard Chapter 5 Trouble Shooting Start up problems during assembly After assembling the PC for the first time you may experience some start up problems. Connect the case speaker cable to SPK. Checking Jumper Settings This section explains how to set jumpers for correct configuration of the motherboard.
Drivers and software are automatically installed in sequence. Pin 1 is labeled.
However, there is no guarantee that interference. Setting Jumpers Use the motherboard jumpers ec set system configuration options. Due to chipset limitation, please follow closely the table below when installing memory for dual channel or single channel mode operation.
Page 18 Table A: The information in this document is subject to change without notice. The CPU may experience overheating so it will shutdown to protect itself. Page 20 Follow these instructions to install an add-on card: Refer to the illustration below for proper installation: Installing Hardware Installing g31t-3 Processor Caution: Shielded interconnect cables and a shielded AC power cable must be employed with. Neither this manual, nor.